Tips for Garage Door Opener 

Garage doors are an important part of your home furnishing but unfortunately, most of the time they are left neglected whenever a renovation or repair of the household is undertaken. Hence a lot of people encountered malfunctions of the garage doors such as sticking or jammed doors, the unnecessary opening of the doors, or the garage doors not staying open.

As far as sticking or jammed doors are concerned, it is usually caused by deformed door frames and edges or channels through which the door slides. It can be easily fixed without much hassle and stress. Usually, with a simple toolkit of a hammer or mallet, a wrench, a few nuts and bolts, and a screwdriver, you can fix most of these malfunction problems by yourself. 

The unsteady or inconsistent opening and closing of the doors may be due to a depressed key in the opener switch or there might be some problem with your garage door opener circuit that can easily be fixed. But the serious problem arises is when some major part of your garage door develops a fault, for instance, the gears of the door opener. In such cases, a more complicated repair is required. Hopefully, the following steps would provide you with some valuable and useful insight about repairing and replacing the damaged gears in your garage door opener.

You would be able to know if the gear has broken off your garage door even though the motor is working properly and the torsion springs are intact. These gears, typically made of plastic, are among the weaker parts of the opener and can be broken due to some causes like old age, prolonged usage without maintenance, inequality or imbalance in the garage door, or maybe because of a manufacturing defect.

But, with a few common pieces of equipment and following the instructions accordingly, you can change these gears on your own.

First and foremost, you should unplug the electric supply to the garage door to avoid any chance of electrocution so that no one could operate the door while you are working on it. Next, you must close the door manually and take it out from the pulley to guarantee that the door will not hurt you accidentally while you are repairing it. Now you are ready to start fixing your garage door opener and replacing the gears.

The next step is that you need to open the retainer cap of the belt pulley and get the sprocket. Now you can remove the chain or belt from the sprocket after marking its position and tape it to stop it from getting twisted up and cluttered.

Then remove the end covers, the drive gear, the retaining clip, and the RPM sensor to disconnect from the motor. An assembly of nuts holds the motor to the shaft, you need to remove these nuts first. Once you have removed the motor from the driveshaft, you can remove the gear and replace it if necessary. Having replaced the gear, you need to start reassembling the entire system in the exact opposite manner. 

Contact your Garage Door Repair Grayson County TX Today.

Make sure and see to it that each part goes into the correct place to prevent any further problems with your garage door. Consequently, we understand that changing the worn-out gears is a bit more complicated. Hence, if you are not very confident about doing it yourself, you should call an expert and skilled garage door repair service to attend to your garage door problem.